SHARE

Many people want to save money on routine house repairs and one of the most common repairs is replacing roof shingles. Asphalt roof shingles are some of the most common and they can easily be damaged by weather and other conditions. When this happens it’s very normal for just a few shingles to be damaged and yet to have a professional come and repair those few shingles can be very costly.

How To Replace An Asphalt Roof Shingle

1. Start With Safety

Anytime you see a professional working on a roof you will notice that they have a number of safety tools that include effective boots, gloves, and even temporarily installed roof jacks to ensure that they can safely perform the work. If professionals take the time to be safe, then certainly the average layperson should do the same. Accessing the roof will require the use of a strong and sturdy ladder and it’s best to have a second person that stays on the ground and holds the ladder in place.

2. Determine The Damage

Check all areas that might be damaged and depending on what you find it may be necessary to replace the surrounding shingles as well. Be sure to take notice of shingles that have become old or dried out as they should be replaced as well. It is possible to repair a shingle if it’s simply split or cracked but remains in good condition.

3. Remove Shingles When The Weather Is Coolest

When this type of shingle gets hot it’s more difficult to remove. Even if you’re not going to do the repair immediately it’s best to remove the shingles early in the morning. In a situation where there’s no alternative but to remove them during the heat of the day, then you can put cold water on them and soon after remove them which will help them tighten and make it easier despite the heat.

4. Start By Loosening The Adhesive Under The Shingle

To begin removing the shingle it will be necessary to use something like a putty knife or the claws of a hammer to get underneath the shingle and pull it loose from the adhesive. It will be necessary to pull up all the surrounding shingles until you can see the nails and can clearly see all of the damaged roof shingles that need to be replaced.

5. Remove All The Damaged Shingles

Once you have the damaged shingles and those that surround it loosened from the adhesive, then you simply want to remove them. Don’t try to repair shingles that are extremely damaged because it’s a waste of time. Simply replace them with new ones.

6. Install The New Shingle

Make sure to put the new shingle back in the same position as the old one that was removed. It is common for modern shingles to have an adhesive strip which can be used by simply pulling off the covering and then putting them into place. They will also usually have pre-cut holes for the nails to secure the shingle to the roof. Get in touch here to know more http://armorservices.com

NO COMMENTS